Brake Light Flasher Add-On: Raise Conspicuity Now  

Here is the flasher installed on my FJR1300:

(It is the round light just below the license plate)

   Weatherproof, sealed, approximately 3" diameter, 1.5" tall light fixture attaches to your license plate using supplied bracket and hardware. Can be used with your favorite license plate frame - have no fear.

   Includes circuit box with timer delay shut-off, ...upon your braking, your brake lights will come on as usual, this flasher will also come on and start flashing approximately two times a second for about two to three seconds - grabbing peoples' attention so they know you're stopping, ...then it will shut off . It resets immediately for the next braking - ready to flash again upon your next slowdown. Grab those cagers/car-drivers attention with this flasher - don't let your braking light go un-noticed ever again!!!

   Bracket is made out of 0.062 aluminum, nylon 6-6 or stainless steel - to be determined. Comes bare metal/nylon and can be painted to match with rattle can paint - I recommend Krylon brand. (*Nylon will be black - not sure about paint-ability) All circuitry is included and contained in a small plastic housing and easily tucks away out of site. Long wire leads, crimp splices, and instructions are all included and to install only very basic skills and tools are required. I was able to install it within ten minutes with only two tools; pliers and wire strippers. The bracket in the photos below is made of aluminum.

Here is what the Brake Light Flasher looks like when you press on the brakes:

Only two wires to splice into your brake light bulb socket wires:

Splices are included - makes for an easy install: